Làm thế nào để kiểm tra các ngắn mạch và rò rỉ lỗi in the home với vạn năng
Có nhiều cách đến sử dụng vạn năng. Ở đây, I danh sách phổ biến phương pháp đến kiểm tra ngắn mạch% 2c hở mạch và rò rỉ của vạn năng, hy vọng đến giúp đỡ mọi người. Thiếu sót, chào mừng đến thêm.
Kiểm tra ngắn mạch với vạn năng
Kiểm tra liệu có có a ngắn mạch điểm in đường dòng Đầu tiên% 2c cắt tắt mạch cầu dao% 2c sau đó tắt tất cả công tắc và tất cả thiết bị in đường dây (tất cả thiết bị có thể có thể được rút phích cắm nên be rút phích cắm).
The vạn năng selects "buzzer" to measure at the lower opening of the circuit breaker-two probes contact the zero line and live line of the lower opening of the opening of the circuit breaker tương ứng. If the multimeter beeps, it proves that there is a short circuit in the line; On the contrast, there is no short circuit.
All switches are still cut off, and the multimeter selects "buzzer". Make sure to measure the direction of the line and find both ends of the wire.
When measuring, the two probes of the multimeter touch the two ends of the wire tương ứng. If it can beep, it proves that the wire is not open. If there is no beep, it proves that there is a breakpoint in the wire.
What should I do if the distance between the two ends of the wire is too far? Find a wire that is confirmed to be intact and peel off the wires at both ends. One end of the wire is connected to the multimeter, and the other end is used as a probe to contact the line to be tested-this is to extend the length of the probe of the multimeter by using dây, cái nào là thường được sử dụng in thực tế hoạt động.
Đồng hồ vạn năng đến kiểm tra rò rỉ
Don't cut off the circuit breaker this time, just turn off all the switches in the line and unplug all the plugs. Select "750V~ range" for multimeter, and measure at the circuit terminal (measure at at the position of socket, switch, etc., not in the distribution box).
Measure the voltage between live wire-neutral wire and live wire-ground wire respectively. If the two measurements are the same, or the first measurement is less than the second measurement, it is proved that there is no leakage in the line.
If the first measurement value is greater than the second measurement value, it proves that there is leakage in the line-the greater the difference between them, the more serious the the leakage is.
